RF, Microwave & Hardware Engineering Services
RF & Microwave Engineering and Hardware Design & Development are our two core divisions. Engage us for a specific task or a broader development scope; requirements, feasibility and deliverables are reviewed before work is agreed.
01 · Requirements & Feasibility
Before any design work starts, we make sure the project is well understood.
- Requirement analysis
- Technical feasibility
- Architecture & component strategy
- Power budget & interface definition
- Preliminary BOM
- Engineering risk identification
02 · Electronics / Circuit Design
Analog, digital and power electronics, designed around your constraints.
- Analog, digital, mixed-signal
- Power electronics
- Sensor interfaces
- MCU-based systems
- Battery systems & charging
- Protection circuits
03 · PCB Design
Schematic capture, layout and manufacturing outputs agreed for the project.
- Schematic capture & layout
- Multilayer layout; high-speed requirements reviewed during scoping
- Signal & power integrity
- Thermal considerations
- DRC & design reviews
- Gerber & manufacturing files
04 · Embedded Hardware
Hardware built around the right processor for the job.
- Microcontroller selection against requirements
- Processor and system-interface review
- FPGA/CPLD where applicable
- Embedded peripherals, sensors, displays
05 · Firmware
The software layer that makes the hardware do its job.
- Embedded C/C++ & device drivers
- Sensor integration
- UART, SPI, I2C, CAN, USB; connectivity features where agreed
06 · Prototype Development
Prototype planning, external build coordination and board bring-up.
- External PCB fabrication & assembly coordination
- Component procurement
- Bring-up & debugging
- Functional testing & iterations
07 · Testing & Validation
Practical checks against the agreed requirements and operating conditions.
- Project-relevant RF measurements
- PCB bring-up & debugging
- Functional & integration testing
- Prototype verification
08 · DFM / Production Engineering
Preparing the design to be built at scale.
- DFM & DFT
- BOM optimization & alternate sourcing
- Cost optimization
- Manufacturing documentation
09 · RF & Microwave Engineering
Custom RF circuits, modules and subsystems developed around system requirements.
- Power amplifiers, TR modules & channelised receivers
- Frequency conversion, RF front ends, analysis & integration
10 · Manufacturing Support
Engineering documentation and coordination with external manufacturers, where agreed.
- Vendor coordination & sourcing
- PCB fabrication & PCBA
- Pilot-build support where scoped
- Agreed inspection activities & engineering handover
Explore each service in detail
PCB Design
Schematics, PCB layout & agreed manufacturing filesRF Hardware & Integration
RF PCB interfaces, subsystem integration & measurementsDigital Hardware
MCUs, processors, memory & scoped interfacesAnalog & Power
Sensor front-ends, batteries, DC-DCEmbedded Systems
Firmware, peripherals & scoped connectivityFPGA Design
Programmable logic & digital interfacesPrototyping
External build coordination & bring-upHardware Testing
Measurements, debugging & prototype verificationDFM Review
Cost, yield and assembly checksManufacturing Support
Manufacturing documents & external coordinationNot sure which services you need?
Tell us what you're building — we'll scope it together.